tds corner bracket corner tubes checkline

Fall protection / Documentation

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

1. TECHNICAL DATA SHEET CORNER BRACKET W/ FIXING POSTS TDS42 Corner Bracket with Fixing Posts Technical Data Sheet TDS42 ISSUE 05 NOTE: TWO TUBES ARE REQUIRED PER BRACKET Checkmate Checkline II Corner Bracket . The Corner Bracket can be mounted onto the TopFix post and is used to support the 8mm wire rope via the corner tubes. The special rubber dampers are energy absorbing and will reduce the impact forces by up to 67% in the event of a fall. The bracket has the ability to be rotated through 180° and set at intervals of 30° Three varieties of tubes are available to create 0°, 15°, 30°, 45°, 60°, or 90° corners. The corner tubes can also be rotated to accomodate vertical as well as horizontal changes in direction. Corner tubes available: 0°, 15° and 45°

2. Using fall arrest equipment is only a part of working safely at heights; get accredited height safety training from HART. For more information visit www.h-a-r-t.co.uk Corner Bracket with Fixing Posts Technical Data Sheet ordering information Part No. Description Weight  PPESLL-503 Corner Bracket c/w TopFix Post 1.72kg  PPESLL-328 Straight Tube >0.1kg  PPESLL-345 Corner Tube 15° >0.1kg  PPESLL-307 Corner Tube 45° >0.1kg principal materials  Body & Post Sleeve  Cast Stainless Steel - Powder Coated Grey  Corner Bracket  Cast Stainless Steel - Electro Polished  Damper  Rubber EPDM  Star Washer, M16 Hex Nut & Corner Tubes  Stainless Steel  Sealing Gasket (if required)  Neoprene standards  These components form part of the  Chec kmate EN 795 system TDS42 ISSUE 05 CHECK US OUT www.checkmateuk.com The information on this data sheet is for marketing purposes only and Checkmate reserves the right to amend at any time without notice. The information must not be relied on for use, which must be obtained from the product marking and user information. DISCLAIMER – COMPONENTS MUST BE USED AS PART OF A COMPLETE CHECKMATE CHECKLINE SLL SYSTEM, COMPRISING OF CHECKMATE COMPONENTS ONLY. STRUCTURAL ENGINEER APPROVAL IS REQUIRED BY BUILDING OWNER. SPECIFYING AND INSTALLING CHECKLINE REQUIRES TRAINING AND WRITTEN APPROVAL FROM CHECKMATE – CONTACT CHECKMATE FOR DETAILS. Ø64mm Ø8.5mm 70mm Ø106mm 204mm 60mm Centres

Views

  • 137 Total Views
  • 120 Website Views
  • 17 Embeded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+